Activity Stream

Well, t26960505 looks like a part number to me.

Hey Guys, just wanted to post this up here as I just found this link in my bookmarks from a good while ago, but might help in your search:...

What kind of conditions with air filter? Check your MAP sensor for dirt. Clean it. If it is still causig engine light. O2 sensor should be...

P2096 is a consequence of P0139, not another fault. HO2S Sensor 2 is located after the catalytic. ...

Im not usually a fan of immediately jumping to replace oxygen sensors, but with two codes pointing to the same sensor, i say go for it. Sent from...

Hi Guys, I spoke too soon. The light came on again and trying the gas cap remedy didn't change anything. So, this morning I scanned the OBDII with to...

That's a shame you missed driving a s2000 for a week. I'm sure it won't happen again.

That would be a p0457. A buddy of mine had an s2000 years ago and loaned it to me when he was out of town. I gassed it up and threw a light the...

Good Morning, I read on another Suzuki forum yesterday about someone having the same issues as me and the solution to their problem involved the gas...

Obviously you want to track down and correct the cause of the check-engine light, but in a pinch you can disconnect and reconnect the battery to...

Yeah...as nobutter said, read that the opposite way ...the check engine came on...and then...the cruise control kicked off.... Very often this comes...

nobutter69 thank you again. I'll comment when I get it corrected. Thanks again. bobg1726

The port is tucked in pretty tight under the driver's side knee panel. Get a flashlight, get down on your knees next to the car, and look up and in...

nobutter69 and vhercules I really appreciate your comments. They are going to save me a lot of money. Thank you, bobg1726

That is the correct way ... I have had both the seals on my sx4 go over the last 3-4 years. This method actually saves a lot of labour time if i...

You do not remove the clip. The method with the prying it out is correct, and not really hard. Sent from my SM-G935V using Tapatalk

I did clean the pvc. There are no codes except when I disconnect something. Mileage is 100k something miles. We have never changed the...

This is not the first time this issue has come here but after several ways to investigate the problem have been suggested by forum members, the final...

well it is possible your level switch is ill positioned..because mine (uinderstand wife's SX4) went to complete wear out of rear brake pads and the...

I’m in Victoria. Seems the light and “limp mode” are separate issues. I think limp mode is relative only to load restriction of CVT tranny. The...

When was last time you change Auto tranny fluid? May affect idle speed. Have you cleaned pcv? Any obd codes? What is current mileage on SX4?

MAF measures the air flow to deliver the proper amount of fuel. DIsconnectong the maf most probably turns the engine control to default mode and...

I have a 2008 SX4 AWD hatch (US version), and recently posted a video showing how to install a seat sensor emulator and seatbelt latch emulator in my...