Activity Stream

You will have to build your own. The rrm kit never was a good kit because of the cheap manifold and 5th injector.

All-terrain vehicles (ATVs), off-highway motorcycles or dirt bikes, Utility Terrain Vehicles (UTVs or side-by-side vehicles), snowmobiles, and...

Nice job. Always good peace of mind to do the work yourself and know it was done to your standards.

I've had my belt out numerous times and never had any problems getting it back on. The belt will sit on all the pullies and idlers just fine then you...

Mission accomplished. Besides the standard tools, I recommend having a wire hanger and a poking stick on hand to get the belt on. I fished the new...

I started looking at tires again tonight. The cheapos that the dealer put on when they sold me the (used) SX4 wore out after a couple of seasons. I...

Has anyone had issues with an installer refusing to mount the slightly bigger tire? '13 Suzuki SX4 6spd AWD

I did the crossmember that runs fore-and-aft last year because it was looking sketchy. The side-to-side cross member looks solid, but it just doesn't...

I think the SX4 got the J20B in 2010, at least in the US, not sure about Australia. Henno - transverse engines are set up quite differently to...

Hi, thanks much for replying. That link looks like it might have everything I need, will definitely contact them. BTW it is in fact an SX4, it...

Is your car a SX4 S cross? The SX4's that we all know around here ended in 2013. As for the steering wheel control interfaces a few years ago I...

...One of the idlers .../QUOTE] one is an idler, the other a tensioner. Tensioner diameter for the J20A (2007) is larger than for the J20B...

Accurate enough, idler pulley #6 is closer to PS pulley than WP pulley. J20b belt routing is same as J24b found in Grand Vitara.

I can't remember how accurate this drawing is but I have it saved from some years ago doing the same. I'll toss it out there in hopes its helpful but...

New starter installed today ... she fired right up! YAY! That code gave me a few sleepless nights but alls good. Bad starter --> turn key --> no...

I’ve seen it done, but make sure that engine support crossmember, the one that has the front engine mount bolted to it, is not rotted as that is very...

Does not look right, it is a spacer lift and not like adjustable shocks or something .... looks like front was not put on

Hii Friends, Sure, here is a list of common car failures, faults, and broken things: Dead battery, Flat tire, Faulty alternator, Broken starter...

Sadly, that would end up really expensive shipped to Brazil plus import fees. Enviado de meu Mi A3 usando o Tapatalk

First I have check underneath to see exactly how that part fits around the tank. Have to make sure I can remove the 4 bolts that are screwed into the...

I recommend filling the fuel tank. :)

I'm going to guess they didn't put the front kit on.

Quite the adventure! What are you going to do about the heat shield?